MODELS 640 AND 641 FORK SHACKLE BOLTS It has been found that when the set screws are tightened on the...
SPARK PLUGS The spark plug provides suitable electrodes inside the cylinder, which can be jumped by a high voltage from...
133 November 14, 1941 – Unnecessary Wheel Bearing Failures on Models 640 and 641 Care must be used when assembling...
Page 1 and 2 Readable…… Page 3 INSTRUCTIONS FOR ASSEMBLING RADIO SHIELD OVER DISTRIBUTOR This shield is packed with the...
INSTRUCTIONS FOR REMOVING REAR SPRING ASSEMBLY FROM LATE MODEL FRAMES Right or left side. Remove upper sleeve lock screw (10-32)...
The posts of the regulator for indicator light wire, and battery wire are stamped T and B. ‘. Care must...
FLYWHEEL ASSEMBLY TIGHTENING OF PINION SHAFT, DRIVE SHAFT AND CRANKSHAFT INTO THE FLYWHEELS: (We recommend the use of a Torque...
PINION SHAFT AND SHIFTER FORK CRANK CHANGES On the 741 engines starting with the numbers GDA-32037, the flywheel pinion shafts...
GENERATOR BELT PART NO. 42603 Because it was impossible for the belt manufacturers to supply us with the same belt...
