1901-1953 Indian Motorcycle – Parts – Accessories

Shopping cart
$0.00
  1. Home
  2. Knowledge Base
  3. Indian Factory Service Shots
  4. 1947 Service Shots
  5. 180 – How To Adjust The Beam On Spotlight #561004

180 – How To Adjust The Beam On Spotlight #561004

HOW TO ADJUST THE BEAM ON SPOTLIGHT #561004

The beam may be adjusted by removing the lens and sliding the bulb socket in or out, with the reflector in place, until the desired beam of light is secured.

These spotlights are equipped with a 21 candle-power bulb; however, a 32 candle-power bulb may be inserted if more
light is desired.

In the very near future, all spotlights supplied will contain a 32 candle-power bulb and the beam will be set and fixed in a position for best lighting effect.

ASSEMBLY OF REAR CHAIN CONNECTING LINKS ON ALL 74″ SPRING FRAME MODELS 340-348

The spring clip on the rear drive chain connecting link is assembled on the inside rather than on the outside, because
of the limited amount of clearance between the kickstarter crank stop and the fender to spring frame slipper bracket
bolt.

When the chain comes loose, there is a possible chance that the chain connecting link clip will strike against the head
of the bolt or kickstarter stop and get knocked off.

Make sure when you reassemble the rear drive chain that you assemble the connecting link with the clip on the inside.

Walter Brown
Service Manager

Was this article helpful?

Related Articles

Leave a Comment

Leave a Reply

Need Support?

Can't find the answer you're looking for?
Contact Support